Nivian - Manual Reset - NVS-VIDEOINTERCOM-2W // NVS-VIDEOINTERCOM-2W-KPAD

Manual reset of the NVS-VIDEOINTERCOM-2W // NVS-VIDEOINTERCOM-2W-KPAD

Important note:

• Make sure the system is connected to the power supply.
• Verify that the monitor is connected to the outdoor panel via the 2-wire cable.

Reset procedure:

1. Outdoor panel:
   Locate the button shown in the attached image. Press and hold it for 15 to 20 seconds to reset the device to factory settings.
2. Monitor:
   Use a thin object to press the button (located inside a hole) indicated in the image. Hold it for 15 to 20 seconds until the monitor resets to factory settings.

By performing the above procedure, the monitor and the outdoor panel should link without any issues.