Nivian - NVS-SMARTBOLT - Link with the Tuya Smart App

Procedure to add the HUB to the Tuya Smart application and link RF remote controls.

1- The HUB must be added with the Tuya app and must be connected to power (it does not have a battery).

 HUB

2- Access the Tuya app:

• Tap the icon and select “Add device”. 
• With the mobile's Bluetooth active, the app will detect the HUB to be 
  added. If it does not detect it, you can press the button on the HUB for 10 seconds.
• Press the add button and enter the Wi-Fi password. The Wi-Fi network must be 2.4GHz; the device is not compatible with 5GHz networks.
• Once finished, the HUB will appear in the Tuya app as shown in the following image:

3- Link HUB and remote controls with the lock:

• Press and hold the lock’s "Recoded key" linking button for about 5 seconds until it beeps.
• Then press the HUB switch (indicated in the previous image), followed by the remotes. Press one single button (it can be the open or closed lock button). Repeat this process with each remote without stopping between one and the other (continuously).
• Once all remotes are linked, wait approximately 30 seconds to perform tests.

Note: In the image of the lock, the "Recoded key" button is marked on the right and the "Manual or automatic" switch on the left. You can modify the latter according to your needs:

• Manual: It will only allow management with remotes, app, or manually.
• Automatic: The device will close automatically after about 10 seconds.