Procedure for Adding wired zones / sensors to the NVS-A6WG panel.

• This control panel has 4 wired zones:
  

• The wiring would be as follows:
  Hardwired sensors need four-wire cable, but since actually the common and power negative are the same, what we are going to use are only three wires.
  
  - Two wires go to the power supply of sensor 1 and 6.
  - A jumper has to be made, marked in the image as “B”.
  - And from 2 to 5 are the zones: in the example we have taken zone 2 to connect it to the sensor.
  
  
  
  
  
  SENSOR
  
  
  
  

How to activate and use the wired zones of the NVS-A6WG

The kit has 4 zones, which are defined by connecting the GND pin and the zone pin; it is also possible to power the sensor at 12v by connecting the positive to VCC and the negative to GND.



These zones are enabled and configured from the app, with a simple click in the Detectors/Accessories --> Wired Detectors section.